Martz
Chassis,
INC.
Ford Torino
Rear
Suspension
Installation
1. The front crossmember
locates with the spring perch holes. Make
sure that the crossmember is square before
welding.
2. Cut section of the floor for the rear
crossmember.
3. The center of the rear to the center of the
coil over cross member is 4 ½ “
4. This is the pan hard bracket welded to the
frame
5. This is the 9” rear end bracket for the pan
hard
These are more photos for your reference
http://www.martzchassis.net/torino
